01

Gas Water Heater Warranty Conditions

  1. Warranty is on a ‘bring in’ basis. Should the unit not be able to be removed and a service call is needed to be made outside of the Johannesburg area, there will be a travel supplement charged to the owner.

Warranty Conditions

  1. The warranty is applicable to water heaters manufactured after 1st January 2013
  2. The water heater must be installed in accordance to  water heater installation instructions supplied with the unit, in accordance with relevant local regulations
  3. Where a failed component or water heater is replaced under warranty, the balance of the original warranty period will remain effective. The replaced part or water heater does not carry a new warranty
  4. The warranty only covers the water heater, not any plumbing or electrical parts etc that form part of the installation. Correct and proper installations are not the responsibility  and can affect warranty’s validity
  5. Use on borehole water will INVALIDATE warranty

Warranty Exclusions

The following exclusions may cause the GWH warranty to become VOID and may incur a service charge and/or costs of parts and labour:

  1. Accidental damage to the water heater or any component including Acts of God; failure due to misuse; incorrect installation; attempts to repair the water heater other than by a Accredited Service Agent or the Service Department.
  2. Where it is found there is nothing wrong with the water heater; where the complaint is related to excessive discharge from the temperature and / or pressure relief valve due to faulty plumbing; where water leaks are related to plumbing and not the water heater or water heater components; where the supply of gas, electricity or water does not comply with relevant codes or acts.
  3. Where the water heater or water heater component has failed directly or indirectly as a result of: excessive water pressure; excessive temperature and / or thermal input; corrosive atmosphere; ice formation in the pipe work to or from the water heater; ice formation in the waterways of a water heater without a frost protection system; ice formation in the water with a frost protection system where the waterways of an electricity supply has been switched off or has failed and the water heater has not been drained in accordance with the instructions; ice formation in the waterways of a water heater with a frost protection system due to an ambient temperature below -20’C (including wind chill factor); ice formation in the water ways of a water heater where the water heater has not been installed in accordance with the water heater installation instructions.
  4. Where the water heater is located in a position that does not comply with the water heater installation instructions or relevant statutory requirements, causing the need for major dismantling or removal of cupboards, doors or walls, or use of special equipment to bring the water heater to floor or ground level or to a serviceable position.
  5. Repair and/or replacement of the water heater due to scale formation in the waterways or the effects of corrosive water when the water heater has been connected to a scaling or corrosive water supply as outlined in the Owner’s Guide and installation instruction booklet.
  6. Poor quality gas supply, oil residue etc found in gas components will not be covered under this warranty.

 

SUBJECT TO ANY STATUTORY PROVISIONS TO THE CONTRARY, WARRANTY EXCLUDES ANY AND ALL CLAIMS FOR DAMAGE TO FURNITURE, CARPETS, WALLS, FOUNDATIONS OR ANY OTHER CONSEQUENTIAL LOSS EITHER DIRECTLY OR INDIRECTLY DUE TO LEAKAGE FROM THE WATER HEATER, OR DUE TO LEAKAGE FROM FITTINGS AND/OR PIPE WORK OR METAL, PLASTIC OR OTHER MATERIALS CAUSED BY WATER TEMPERATURE WORKMANSHIP OR OTHER MODES OF FAILURE.

Warranty Coverage

Gas Water Heaters in South Africa. Will repair, replace any component or arrange the installation of a new water heater, which falls within the warranty periods specified below, as deemed necessary.

 

Water Quality

Water quality is VITAL to the operation of your Paloma Gas Geyser – the use of borehole water will invalidate the warranty. Therefore to ensure the longevity and validity of your warranty, the composition of water being used within the unit should not exceed the following parameters: 

DESCRIPTION MAXIMUM LEVELS
pH 6.5 – 8.5
TDS (Total Dissolved Liquids) Up to 500 mg/L
Total Hardness Up to 200 mg/L (11.7 gpg)
Aluminium Up to 0.2 mg/L
Chlorides Up to 250 mg/L
Copper Up to 1.0 mg/L
Iron Up to 0.3 mg/L
Manganese Up to 0.05 mg/L
Zinc Up to 5 mg/L

SAFETY

This water heater is supplied with temperature sensors, a FlameSafe™ protection system and a pressure relief valve. These devices must not be tampered with or removed. The water heater must not be operated unless each of these devices is fitted and is in working order.

If the power supply cord or plug is damaged, it must be replaced by an authorised person in order to avoid a hazard. The power supply cord and plug must be replaced with a genuine replacement part available from your nearest Paloma Service centre.

The warranty can become void if relief valves or other safety devices are tampered with or if the installation is not in accordance with these instructions.

This water heater is only intended to be operated by persons who have the experience or the knowledge and the capabilities to do so. This water heater is not intended to be operated by persons with reduced physical, sensory or mental capabilities i.e. the infirmed, or by children. Children should be supervised to ensure they do not interfere with the water heater.

The water heater uses 230Volt AC electrical power for operation of the control systems and the combustion fan. The removal of the front panel will expose 230V wiring. It must only be removed by an authorised or qualified person.

The power lead from the water heater must be plugged into a weatherproof electrical outlet. Take care not to touch the power plug with wet hands.